How to DIY: Installing Your Own Cabinet Hardware Like a Pro

Cabinet hardware is one of the easiest DIY projects that can help to revamp your kitchen or any part of your home with a lot of cabinets. Whether you are repainting old cabinets or adding the final touches to newly created ones, the right hardware can go a long way. This do it yourself guide will guide you on how to do it right and use the right products from the leading kitchen hardware companies.

Choosing the Right One

However, it is important to choose the right hardware before proceeding to the installation process. Kitchen hardware companies provide a wide variety of styles, finishes, and types to suit any design. When selecting the hardware, it is important to think about the purpose of the area and the convenience of the design, especially in areas that are frequently used.  

Tools and Materials Needed

To install cabinet hardware like a pro, you’ll need the following tools and materials:To install cabinet hardware like a pro, you’ll need the following tools and materials:

  • Measuring tape
  • Pencil or marking tool
  • Use the right drill bits
  • Screwdriver
  • Level (to ensure alignment)
  • New hardware and screws (normally supplied by the cabinet hardware manufacturers).

Having these tools beforehand will reduce the time taken to install the system and also avoid any interruption that may arise from having to look for the tools.

Marking the Drill Points

One of the most important aspects of the hardware installation process is to identify the right spots to drill. Take measurements of the distance between the screw holes on the hardware and then mark these measurements on the cabinet. With a pencil, draw where you want to drill. As a rule, it is better to measure twice before you mark, in order not to make a mistake. 

Drilling the Holes

After you have your drill points marked, then you can proceed to drill. Choose the right size of the drill bit to be used on the drill; this is often indicated in the hardware instructions from the cabinet hardware makers. Drill at a slow pace to prevent the wood from splintering and to create clean holes. It is always recommended to begin with a smaller pilot hole and gradually increase the size.  

Precision and Alignment

Once all the hardware is installed, take a step back and look at the alignment of the pieces. If any of the handles or knobs are slightly misaligned, then you need to unscrew them and make slight adjustments until all the handles or knobs are aligned properly. Level it to ensure it is properly aligned especially for long handles on drawers. This step is very important in order to get a professional look.

In conclusion, putting up your own cabinet hardware is a relatively easy project that can greatly improve the appearance of your furniture. If you choose good quality hardware from a good kitchen hardware manufacturer, measure well and follow these steps, you can install your cabinet hardware like a professional. Just remember that even a small amount of work can make a big difference when it comes to the appearance and utility of your cabinetry!

Leave a Comment